The initial phase, free of rules and limited to 135-class karts, was followed in the early 1990s by one that identified its potential function in reducing the risk of "wheel-to-wheel" contact, the cause of the most classic accidents of the era: rollovers.
.jpg)
The lateral bodywork (side pods), introduced to provide minimal space for sponsors ended up reducing the number of rollovers, as it made wheel-to-wheel contacts less frequent
Pierluigi Giacoletto's vision, as an amateur driver, is one that looks to the long term, aware of the direction the sport would take. The evolution of karting rewards his pioneering spirit: starting with steering wheel production for DAP—the wheels gripped by Ayrton Senna—he founded KG, which from the early 1990s became the reference standard for bodywork in World Karting.
.jpg)
It wasn't the bodywork but kart steering wheels that were the first creations in KG's Piedmont (North East of Italy) headquarters, with DAP as the first customer: none other than the karts made famous by Ayrton Senna at the turn of the 1970s and '80s. Today, KG produces - practically - the steering wheels for all karts on the planet
Karting is (also) a contact sport and the presence of bodywork plays a major role in regulations: first FMK (Karting was not yet part of the FIA), then CIK, and finally FIA began introducing reference standards: standard measurements first, unique design in 1992, homologations from 2002. In 2003 came homologation with crash tests. But what are bodyworks made of?
The material poured into the molds is High-Density Polyethylene (technical name HDPE), and for a kart's side pods and bumpers, the technique used is blow molding, creating what is essentially a sort of "already exploded airbag" in a material elastic enough to cushion impacts in a vehicle—the only one in the FIA Motorsport chain that cannot rely on a survival cell, as in single-seaters from F4 to F1.
.jpg)
The material in which the bodywork is molded is HDPE (High-Density Polyethylene), a thermoplastic polymer
With the arrival of rear bumpers in 2006, karting changed almost definitively, leading to new rules in 2014 and then 2016 to determine when a driver's "clever" use of these plastics could influence the result. It was in this context that KG interpreted the regulatory change introduced by the new rule on bumper setback, introducing a "passive" verification system: no longer just protective plastic, but an integral part of the sport and regulations, used in parc fermé to penalize drivers who too aggressively "lean on" the kart ahead, especially during overtaking maneuvers.
.jpg)
The first rear bumpers in FIA races, back in 2006
CFD studies in wind tunnels arrived significantly with the latest homologations from 2023 in particular: reducing drag to improve the kart's aerodynamic efficiency. The kart not only changes appearance but does so to respond even more to its nature as a racing vehicle. KG also still produces steering wheels for essentially every kart in the world, as well as tanks, airboxes, and all kinds of accessories. The attention to detail is meticulous, with steering wheels hand-welded and stitched one by one, and nothing is left to chance—before FIA crash tests, they are simulated here in the factory to test the forces at play in bumper setback during rear-end collisions.
KG's research and development work doesn't stop, and whatever the needs of a sport changing again in its regulations, the challenge is accepted: from rental tracks to World Championship circuits, to make karting safer, more efficient, and why not, more beautiful to watch.








